A Novel Low-Cost Fabrication Process for Bulk- Mode Resonators in X-Ray LIGA Technology

Publish Year: 1391
نوع سند: مقاله کنفرانسی
زبان: English
View: 1,565

This Paper With 6 Page And PDF Format Ready To Download

  • Certificate
  • من نویسنده این مقاله هستم

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این Paper:

شناسه ملی سند علمی:

ICEE20_159

تاریخ نمایه سازی: 14 مرداد 1391

Abstract:

This paper presents design and fabrication process of a bulk-mode ring resonator in x-ray LIGA technology. The fabrication process is used to achieve a high aspect ratio of 25with 3-4 μm gap spacing. Rigid graphite serves as a low-cost primary substrate and plating base of nickel as structuralmaterial. Moreover, low-cost x-ray mask is developed based on silver electroplating procedure. Through the combination of xray and UV lithographies, the fabrication process needs onlythree lithography steps with one x-ray mask and two Mylar masks. The resonant behavior of the fabricated resonator ischaracterized as a function of the bias voltage using a fully differential drive and sense interface circuit. The results showthat, the quality factor of the fabricated resonator in the extensional wine-glass resonant mode is about 156170 using a DC-bias voltage of 90 V at a resonance frequency of 9.37 MHzand vacuum pressure of 0.10 mbar

Authors

Abolfazl Bijari

Ferdowsi University of Mashhad

Sayyed-Hossein Keshmiri

Ferdowsi University of Mashhad

Arisara Leenaphet Winai

University of Technology (SUT

Chanwut Sriphung

Synchrotron Light Research Institution (SLRI)Nakhon Ratchasima, Thailand