Experimental and numerical investigation of groove pressed UFG pure aluminum

Publish Year: 1389
نوع سند: مقاله کنفرانسی
زبان: English
View: 1,471

This Paper With 5 Page And PDF Format Ready To Download

  • Certificate
  • من نویسنده این مقاله هستم

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این Paper:

شناسه ملی سند علمی:

EASTTEHRANMECH01_127

تاریخ نمایه سازی: 2 اسفند 1389

Abstract:

Fabrication of ultrafine grained materials by imposing severe plastic deformation for improvement of mechanical and physical properties of metals have been focused of many researches over the past few years. In this process, sheet is subjected to repetitive shear deformation conditions by utilizing asymmetrically grooved and flat dies through alternate pressing. In this study, a 2mm thick commercial pure aluminum sheet was subjected to repetitive pressing up to four passes. Mechanical properties including, hardness and tensile were obtained. Results show that, although increasing the number of the passes causes higher strength magnitude, the strength’s slope decreases. After validation of finite element modeling, strain distribution and uniformity behavior of the grooved plate were investigated using plain strain and plain stress conditions. Results shows that strain in the surface and near the teeth of die are lower than other areas.

Authors

A Sajadi۱,

۱M.Sc. student, Iran University of Science and Technology

F Djavanroodi۲,

۲Associate professor, Iran University of Science and Technology

M Borhani۳

۳M.Sc. student, Iran University of Science and Technology

مراجع و منابع این Paper:

لیست زیر مراجع و منابع استفاده شده در این Paper را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود Paper لینک شده اند :
  • -Dong Hyuk Shin, Jong-Jin Park, Yong-Seog Kim, Kyung-Tae Park, "Constrained ...
  • -Kaiping Peng, Lifeng Su, Leon L. Shaw, K.-W. Qian, "Grain ...
  • - E. Hosseini, M. Kazeminezhad, A. Mani, E. Rafizadeh, "On ...
  • _ Conference on Mechanical Eng i neering-RCME2 1 1 March ...
  • - J.W. Lee, J.J. Park, "Numerical and experimental investigations of ...
  • - Kaiping Peng, Ying Zhang, Leon L. Shaw, K.-W. Qian ...
  • pressing", Acta Materialia 57 (2009) 5543-5553 Khajeh, ...
  • :Experimental and finite element investigation of semi- constrained groove pressing ...
  • نمایش کامل مراجع