Elasto-plastic simulation of bullet penetration into Al۷۰۷۵-SiCp composites armor
Publish place: The 7th International Conference on Composites: Characterization, Fabrication and Application
Publish Year: 1399
نوع سند: مقاله کنفرانسی
زبان: English
View: 427
متن کامل این Paper منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل Paper (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- Certificate
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
COMPOSIT07_100
تاریخ نمایه سازی: 18 خرداد 1400
Abstract:
I this study, penetration of a piercing projectile into Al۷۰۷۵-xSiCp (x=۳ ,۶, ۹) composite plates will be investigated by finite element (FE) analysis. The simulation of ballistic impact on a thick hexagonal armor was derived in clamped boundary conditions by ABAQUS software. The proposed simulation is verified by observing agreements to those available in the literature. Finally the influence of material properties and velocity of bullet are examined and discussed in detail. An increase in absorbed energy and a further decrease in bullet velocity were observed for ۹% silicon carbide composite. The critical damage zone also increases with increasing percentage of reinforcement
Keywords:
Elasto-plastic impact , Finite element analysis , Reinforced armor , Von Mises stress distribution , Absorbed energy.
Authors
Y Peimaei
MSc student, Faculty of Technical and Engineering, Islamic Azad University of South Tehran, Tehran, Iran
N Khademian
Researcher, Department of Quality, SAPCO, Tehran, Iran