Mechanical Characterisation and Comparison of Hyperelastic ‎Adhesives: Modelling and Experimental Validation

Publish Year: 1401
نوع سند: مقاله ژورنالی
زبان: English
View: 142

This Paper With 11 Page And PDF Format Ready To Download

  • Certificate
  • من نویسنده این مقاله هستم

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این Paper:

شناسه ملی سند علمی:

JR_JACM-8-1_027

تاریخ نمایه سازی: 8 آذر 1400

Abstract:

This work focuses on the mechanical characterisation of adhesives with hyperelastic behaviour, and on the determination of the behavioural laws that best represent them, in order to be able to introduce them into simulation models. There are virtually no references to the characterisation of these materials in the literature, so it has been decided to use the methodologies commonly employed with other hyperelastic materials, such as rubber, whose behaviour is similar to that of highly flexible adhesives. Firstly, a test plan is carried out on simple specimens, uniaxial and planar configurations, designed to measure the non-linear behaviour of the adhesives in both tension and shear. Subsequently, using finite element models of the tested specimens, different behavioural laws from those usually used for the representation of hyperelastic materials are tested. Based on the experimental results, the parameters of the different laws proposed are adjusted, and the results are compared. In conclusion, it has been determined that the Mooney-Rivlin model is the one that allows the best fit, and therefore may be the most suitable to represent the behaviour of hyperelastic adhesives. For the adhesive used in this work, the obtained law has been validated by comparing the results of tests on single lap adhesive join (SLJ) specimens with the results predicted by the simulation.

Authors

Francisco J. Simon Portillo

Department of Mechanical and Energy Engineering, Universidad Miguel Hernández, Elche, ۰۳۲۰۲, Spain‎

Óscar Cuadrado Sempere

Department of Mechanical and Energy Engineering, Universidad Miguel Hernández, Elche, ۰۳۲۰۲, Spain

Eduardo A.S. Marques

Department of Mechanical and Energy Engineering, Universidad Miguel Hernández, Elche, ۰۳۲۰۲, Spain

Miguel Sánchez Lozano

Institute of Science and Innovation in Mechanical and Industrial Engineering (INEGI), Porto, ۴۲۰۰-۴۶۵, Portugal‎

Lucas F.M. da Silva

Department of Mechanical Engineering, Faculty of Engineering, University of Porto, Porto, ۴۲۰۰-۴۶۵, Portugal

مراجع و منابع این Paper:

لیست زیر مراجع و منابع استفاده شده در این Paper را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود Paper لینک شده اند :