Effect of Side Wall Expansion Angle on the Performance of a Dump Diffuser Model for a Combustor

Publish Year: 1398
نوع سند: مقاله ژورنالی
زبان: English
View: 239

This Paper With 14 Page And PDF Format Ready To Download

  • Certificate
  • من نویسنده این مقاله هستم

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این Paper:

شناسه ملی سند علمی:

JR_JAFM-12-6_022

تاریخ نمایه سازی: 15 دی 1400

Abstract:

In the present article, numerical analysis has been performed on a dump diffuser model, to study the effect of sidewall expansion angle (SWA), on its performance aspects. SWA has been varied from ۹۰° to ۱° and performance has been evaluated in terms of major influencing aspects. It is observed that, at SWA of magnitudes greater than ۱۱°, there is no significant change in the performance. But at SWA below ۱۱°, significant changes, which enhance the performance are observed. It is noticed that at SWA in range, from ۳.۵۷° to ۸°, higher static pressure recovery (almost from ۲۵ to ۳۳% of inlet dynamic pressure) happens in the dump and annular regions. SWA of magnitudes less than ۱۱° have resulted in smaller, low dense and higher intense recirculation zones. At the SWA of ۳.۵۷°, static pressure recovered is maximum and total pressure lost is minimum. But that SWA causes too much delay in pressure stabilization on the liner wall. However, SWA of magnitudes less than ۳.۵۷° have resulted in comparatively poor performance. Eventually, sidewall angle in the range from ۵° to ۷° is found to be optimum as it yields higher static pressure recovery and low total pressure loss. This range also results in early stabilization of pressure both on the liner and casing walls.

Authors

T. B. V. Chetan

Department of Mechanical Engineering, Indian Institute of Engineering Science and Technology, Shibpur, Howrah-۷۱۱۱۰۳, West Bengal, India

S. Chakrabarti

Department of Mechanical Engineering, Indian Institute of Engineering Science and Technology, Shibpur, Howrah-۷۱۱۱۰۳, West Bengal, India