Microstructure Investigation and Weld Zone DimensionMeasurement of Haynes ۲۳۰ Super Alloy Welded by Three Different Method
Publish Year: 1400
نوع سند: مقاله کنفرانسی
زبان: English
View: 104
متن کامل این Paper منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل Paper (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- Certificate
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
INCWI22_075
تاریخ نمایه سازی: 16 فروردین 1401
Abstract:
Nickel base super alloy Haynes ۲۳۰ is not only used for gas turbine components but also some combustion chambers and nozzles in thrusters or airspace engines are made of this material. This research investigates the microstructure and measures the weld dimension of Haynes ۲۳۰ super alloy made by three different welding methods consist of PAW, LW, and EBW. Parameters of each welding method like current, linear velocity, and beam power were chosen based on experience to create an acceptable appearance weld joint. Then face width, penetration depth, and heat-affected zone size were measured andcompared by image analyzer software. The microstructure of samples was investigated by optical and electronic microscopy equipped with EDS chemical analyses. Investigations have shown that LW has the maximum face to depth ratio among samples of this research. Moreover, a minimum melting of carbide phase in weld zoon was observed in LW either
Keywords:
Authors
Y Vahidshad
Assistance Professor, Space Transportation Research Institute, Iranian Space Research Center,
A. H. Khodabakhshi
Researcher, Space Transportation Research Institute, Iranian Space Research Center