Karim Sharifat - Business manager
Lope Tabil - Department of Chemical and Biological Engineering, University of Saskatchewan, Saskatoon, SK, Canada
Bill Crerar - Chemical and Biological Engineering University of Saskatchewan Canada

Measurement of mechanical properties of biocomposites is a good method for evaluating their effectiveness of adhesion between fiber and polymer matrix. In this research, the effects of four different chemical treatments of flax fiber on some mechanical properties of their biocomposites was investigated. Initially, the flax fiber was soaked in alkaline, silane, benzoyle and peroxide solution and the fiber were dried in an air-cabinet drier at ۷۰°C. After grinding, each group were separately mixed with HDPE powder at a ratio of ۱۰% flax fiber and ۹۰% HDPE. From these mixture, composite plates were prepared through extruding, pelleting, and rotational molding. The resulting composites were tested for their various mechanical properties using tensile tests. The test results indicated the maximum strain was ۶.۲۲%, maximum supported load at yield point was ۵۸۲ N, maximum stress at yield pint was ۲۰.۲۶ MPa and maximum modulus of elasticity was ۴۶۷.۷۵ MPa all for alkaline treatment. It was found that all tested mechanical properties for HDPE were significantly lower than the composites made from fiber containing biocomposites. However there was no significant difference between the mechanical strength of composites produced from various chemical treatments.

flax fiber, biocomposite, chemical treatment, engineering properties