Vahid Norouzifard - Department of Mechanical Engineering, Jundi-shapur University of Technology, Dezful, Iran
Ashkan Nazari Siahpoush - Department of Materials and Metallurgy Engineering, Islamic Azad University-Dezful baranch, Dezful, Iran
Amir Talebi - Faculty of Materials & Manufacturing Technologies, Malek Ashtar University of Technology, Tehran, Iran

In this study, the microstructure, tensile, and fatigue behavior of the copper matrix composites reinforced by steel particles are investigated. The composite grades containing ۲.۵, ۵.۲, and ۷.۴ wt% steel particles up to ۹۰ µm in size are manufactured by the casting method. The microstructure of the composite samples is studied by scanning electron microscopy. The tensile and fatigue test samples are prepared and tested based on the ASTM standard. Adding ۲.۵ wt% steel particles to the copper matrix increases the yield strength, tensile strength, and elongation of the pure copper by about ۴۸, ۲۱, and ۴.۸%, respectively. The fatigue test results show that reinforcing the pure copper with ۲.۵ wt% steel particles improves the fatigue life of the pure copper by ۶۷, ۳۱, and ۸۶ percent in ۶۰, ۸۰, and ۱۰۰ MPa amplitude stresses, respectively. On the other hand, further increasing the reinforcement particle content to ۵.۲ and ۷.۴ wt% causes unusual fatigue behavior and adversely affects the mechanical strength of the composite. Therefore, the fatigue life of the composite samples reinforced by more than ۵.۲ wt% steel particles is not a function of the stress level and does not increase with the decrease of the stress.

Composite, Copper, steel particles, Microstructure, Fatigue Test