C. Patel - Department of Mechanical Engineering, Sardar Vallabhbhai National Institute of Technology, Surat
V. Rathod - Department of Mechanical Engineering, Sardar Vallabhbhai National Institute of Technology, Surat
V. Patel - Department of Mechanical Engineering, Sardar Vallabhbhai National Institute of Technology, Surat

Water streams with low heads can be found in India, both naturally as well as through irrigation canals. These natural resources can be used to generate electricity by utilising Hydrokinetic water turbines. The current investigation includes an experimental investigation of the axial flow turbine in order to make use of these naturally available resources. For Axial Flow Turbines (AFT), the influence of the fillet radius at the leading edge corner of the runner blade is studied. The experiments are carried out under various turbine loads and corresponding head conditions. The ۳D printed runners with six different fillet radius (Rtu), i.e. ۰ mm, ۲ mm, ۴ mm, ۶ mm, ۸ mm, and ۱۰ mm are examined experimentally. The results are presented in the form of obtained efficiency (η ) with a diverse Fillet Radius Ratio (FRR) for different Tip Speed Ratio (TSR) and equivalent head (H). The results indicate that, at the head, ۰.۰۱۲ m, with a sharp edge, i.e., FRR = ۰ (Rtu = ۰ mm), the minimum efficiency of ۳۴.۹۰% is recorded. However, at the same water head, the maximum efficiency of ۸۴.۸۲% is achieved with FRR = ۰.۰۴۶ (Rtu = ۲ mm).

Applied fluid mechanics, Renewable energy, Axial flow turbine, Fillet radius, Hydrokinetic turbine