A. R. Arefpour - Advanced Materials Research Center, Faculty of Materials Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Isfahan, Iran
A. Shafierad - Advanced Materials Research Center, Faculty of Materials Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Isfahan, Iran
A. Monshi - Advanced Materials Research Center, Faculty of Materials Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Isfahan, Iran
A. Saidi - Advanced Materials Research Center, Faculty of Materials Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Isfahan, Iran
M. Monshi - Advanced Materials Research Center, Faculty of Materials Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Isfahan, Iran

The aim of conducting this research was to evaluate the viscosity change in the continuous casting of steel mold powders by altering their chemical compositions, using hot stage microscope analysis. ۴ low-fluorine samples containing such compositions as MnO, Fe۲O۳, Li۲O, TiO۲ and ZnO, as well as another fluorine-free sample containing a combination of Fe۲O۳ and TiO۲, were prepared in this research. The viscosity of the reference powder (the mold powder applied in high-speed continuous casting in steel industry), as well as the viscosity of the above-mentioned samples, was evaluated using hot stage microscope analysis. The results of hot stage microscope analysis revealed that the viscosity of the reference powder was similar to that of low-fluorine and fluorine-free samples. Finally, a fluorine-free sample containing a combination of Fe۲O۳ and TiO۲ was introduced as an optimized composition which could be a substitute for the currently-used mold powder applied in the continuous casting of steel with high speed, considering its similar viscosity to be that of the reference powder.

Mold powder, Viscosity, Hot Stage Microscope