Mohsen Vaezzadeh asadi - Marvdasht Branch, Islamic Azad University, Marvdasht, Iran
Ghahraman Solookinejad - Department of physics, Nanotechnology Research Center, Marvdasht Branch, Islamic Azad University, marvdasht, Iran
Heydar Izadneshan - Department of physics, Marvdasht Branch, Islamic Azad University, marvdasht, Iran

Thin layer of titanium dioxide has been deposited on a glass sheet using RF magnetron sputtering under different preparation conditions. Phase, lattice parameters, optical features and morphology were investigated under different laboratory conditions in different thicknesses by using XRD, spectrophotometry and atomic force microscopic (AFM), within the visible spectrum range. Also, the lattice structure, in most cases, is tetragonal or a combination of tetragonal and orthorhombic. The band gap energy for each layer was measured using Tauc’s Plot. It was observed that the edge of absorption is reduced following an increase in thickness except for a thickness of ۷۵ nm. By increasing the pressure, the band gap energy of the layers or the edge of absorption increases except for ۰.۰۴ mbar. By increasing the power, the band gap energy of the layers will change resulting in an increasing-decreasing trend in the edge of absorption, which can be the outcome of changes in the lattice formation. Nevertheless, it is obvious that the band gap energy, phase, lattice parameter and morphology is totally dependent on the laboratory conditions of making layers.

titanium dioxide, Radio Frequency Magnetron Sputtering, X-Ray Diffraction, morphology, Band gap energy, Tauc’s plot