Prediction of effect of microstructure on ultimate tensile strength of Ni-DP steels produced by controlled rolling process using neural network model

Publish Year: 1390
نوع سند: مقاله کنفرانسی
زبان: English
View: 541

متن کامل این Paper منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل Paper (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

  • Certificate
  • من نویسنده این مقاله هستم

این Paper در بخشهای موضوعی زیر دسته بندی شده است:

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این Paper:

شناسه ملی سند علمی:

ICME12_282

تاریخ نمایه سازی: 25 شهریور 1392

Abstract:

In this investigation, the effect of microstructure on ultimate tensile strength (UTS) of dual phase (DP) steels with niobium was investigated. Microstructure consists of: Martensite volume fraction (Vm), ferrite grain size (d) and martensite hardness (HV). These parameters have been correlated with the UTS and are brought out in the form of 3D diagrams. Also, a neural network model based on the Vm, d and HV was used to predict UTS. The results of this investigation show that Vm is the most significant parameter in increasing or decreasing the UTS for this type of steels and there is a good agreement between experimental values and predicted values by artificial neural network (ANN).

Authors

R. Mohamadi

Department of Mechanical Engineering, Amirkabir University of Technology, No.۲۴,Hafez Ave, Tehran, Iran

A. Fallahi

Department of Mechanical Engineering, Amirkabir University of Technology, No.۲۴,Hafez Ave, Tehran, Iran

مراجع و منابع این Paper:

لیست زیر مراجع و منابع استفاده شده در این Paper را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود Paper لینک شده اند :
  • A.Fallahi; J. Mater. Sci. Techno , Vol.18 No.5, 2002. ...
  • M.Sarwar and R.Priestner; J. Mater. Sci, 1996, 31, 2091. ...
  • R.Alderice and E.A.Campbell; Ironmaking and Steelmaking, 1998, 25(6), 435. ...
  • G.R.Speich;Int, Conf. Proc. Fundamental of Dual-Phase Steel, Chicago, Feb 1981, ...
  • M. Edogan, R. Priestner, J. Mater. Sci. Technol. 18 (2002) ...
  • N.J. Kim, A.H. Nakagawa, Mater. Sci. Eng. A83 (1986) 145-149. ...
  • S. Sun, M. Pugh, Mater. Sci. Eng. A335 (2002) 298-308. ...
  • J. Liu, Z. Jiany, J. Liam, Mater. Sci. Technol.? (1991) ...
  • A.Fallahi: Ph.D. Thesis, Sheffield University, U.K., 1990. ...
  • A.Fallahi and C.M.Sellars: The Institue of Metals, Cambridge, UK, 1990. ...
  • A.Fallahi and C.hl.Sellars: Microstructue Control to Achieve Properties in Modern ...
  • D.hIonterio Trejo, J.hI.Gerwick Paulo, C.Ben and G.Thomas: ACI Materias Journal, ...
  • نمایش کامل مراجع