Analysis of a Tilting Pad Journal Bearing's Clearance

Publish Year: 1392
نوع سند: مقاله کنفرانسی
زبان: English
View: 876

This Paper With 13 Page And PDF Format Ready To Download

  • Certificate
  • من نویسنده این مقاله هستم

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این Paper:

شناسه ملی سند علمی:

NCMII01_386

تاریخ نمایه سازی: 22 اردیبهشت 1393

Abstract:

Bearing clearance is one of the most important parameters in the operation of a bearing. Therefore, it’s important to determine the installed clearance space along with the bore contour and concentricity to the outside fit diameter.A method of calculating the clearance space in a tilting pad journal bearing is presented, together with supporting measured data. Three distinct stages of journal position have been identified. In the first stage, the journal can move outwards towards the gap between any two of the stationary, untitled pads until it makes contact with their running surfaces. In the second stage, the shaft can move further outwards, as the pads tilt without sliding until the pad pivot, the journal center and the contact point between pad and journal become collinear. In the third and final stage, the pads slide circumferentially around the bearing homing without further tilting, until contacting their pad stops, thereby allowing further outward motion of the journal. Any or all of these three stages can co-exist to provide the complete clearance space. At the heart of the method of calculation is an expression for the clearance space as a linear combination of the pad tilting angle, pre-set and journal center coordinates. For a large scale model of a typical bearing, the shaft excursion distance at the end of the second stage was calculated lo be 32 mm, which is very close to the observed value of 33 mm. Comparitions are also made between predicted and measured clearance space for a 60 mm diameter shaft in a tilting pad bearing. The ability of a pad to slide in the circumferential direction suggests that, if sufficiently large, pad-stop clearance could have some influence on bearing performance.

Keywords:

Clearance space , Tilting pad journal bearing , Oil film thickness , Pad tilt angle

Authors

ali abasabad arab

Payvaran Parsian engineering co

mohammad abasabad arab

Payvaran Parsian engineering co

مراجع و منابع این Paper:

لیست زیر مراجع و منابع استفاده شده در این Paper را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود Paper لینک شده اند :
  • Armentrout. R. W. and Paquette. D. J., "Rotor Dynamic Characteristis ...
  • -[2] Fu. W. B. and Parkins. D. W., "Mathematicl Analysis ...
  • Parkins, D. W., "Theoretical and Eperimental Determination of the Dynamic ...
  • Parkins, D. W., "Description and Appraisal of some Techniques for ...
  • Fouad Y.Zeidan and Bernard S.Herbage., "Fluid Film Fundamental and Failure ...
  • Nicols, J. C and Kirk R.G., "Four Pad Tilting pad ...
  • Brockwell, K., Dmochow ski, W. and DeCamillo, S. (2004), _ ...
  • نمایش کامل مراجع