a asadi - Water and Wastewater Research Center (WWRC), Department of Applied Chemistry,Faculty of Chemistry, Razi University, Kermanshah, Iran
a.a.l Ziantizadeh - Water and Wastewater Research Center (WWRC), Department of Applied Chemistry,Faculty of Chemistry, Razi University, Kermanshah, Iran Corresponding Author

In this study, the performance of an aerobic sequencing batch reactor (SBR) removing carbon and nutrient (N & P) from Faraman’s industrial wastewater (FIW) was investigated. This study was performed byvarying two significant independent variables viz. aeration time and biomass concentration. The experimentswere conducted based on a central composite design (CCD) and analyzed using response surface methodology(RSM). The region of exploration for the process was taken as the area enclosed by aeration time (6-24 h) andmixed liquor volatile suspended solid (MLVSS) concentration (2000-7000 mg/l) boundaries. Seven dependentparameters as the process responses were measured and calculated. Direct and interactive effects of thevariables on the responses were described by the models given by RSM. The results showed that the maximumtotal COD (TCOD) removal of 73.89% was obtained at the highest value of the factors (24 h and 7000 mg/l). The maximum values of total nitrogen (TN) removal efficiency were found to be 36.39%. The low TN removal directed the study to the reduction of oxygen level from 7 to 3 mg/l. The DO reduction with the extendedaeration mode resulted in an increase in TN removal while decreased the TCOD, non-biodegradable COD(nbCOD) and BOD removal efficiencies. The oxygen concentration had diminutive effect on phosphorus removal.

Sequence batch reactor (SBR) % Industrial wastewater treatment % Simultaneous carbon and nutrients removal