Morphology and Rheological Properties of Copper-Polypropylene Composite as a Candidate for Fusion Deposition Modeling (FDM) Filament

Publish Year: 1395
نوع سند: مقاله کنفرانسی
زبان: English
View: 393

متن کامل این Paper منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل Paper (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

  • Certificate
  • من نویسنده این مقاله هستم

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این Paper:

شناسه ملی سند علمی:

ISPST12_263

تاریخ نمایه سازی: 6 اردیبهشت 1396

Abstract:

Fused deposition modeling (FDM) is almost a new rapid production method using polymers as filament. Highly filled polymers can also be used as FDM filaments. Copper and polypropylene-based binder wase melt mixed in an internal mixer. The conditions of melt mixing were optimized for composites. The state of dispersion of copper powder in polypropylene based binder was examined by SEM and optical microscope. A good adhesion between metallic powder and binder was observed. The rheological properties of the 50 and 60vol% showed that lower rheological properties (almost one third) in case of the 60vol% composite. It was attributed to better filling and stress transfer during mixing in internal mixer chamber. The 60vol% composite was proposed as good candidate as filament for FDM of metallic parts

Authors

Soheil Rezaei Shahmirzadi

Department of Chemical Engineering, Faculty of Engineering, Islamic Azad University-Tehran North, Tehran, Iran

Ali Akbar Yousefi

Derpartment of Plastics, Iran Polymer and Petrochemical Institute, Tehran, Iran

Navid Naderpour

Department of Chemical Engineering, Islamic Azad University, Tehran North, Tehran, Iran

مراجع و منابع این Paper:

لیست زیر مراجع و منابع استفاده شده در این Paper را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود Paper لینک شده اند :
  • O.S. Carneiro, A.F. Silva, R. Gomes, Fused deposition modeling with ...
  • C. Schubert, M.C. van Langeveld, L.A. Donoso: Innovations in 3D ...
  • H. Abdoos, H. Khorsand, A.A. Yousefi, Effect of alumina nanoparticles ...
  • نمایش کامل مراجع