Two-step electrodeposition of CIGS on molybdenum coated copper substrate

Publish Year: 1396
نوع سند: مقاله کنفرانسی
زبان: English
View: 296

This Paper With 6 Page And PDF Format Ready To Download

  • Certificate
  • من نویسنده این مقاله هستم

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این Paper:

شناسه ملی سند علمی:

IMES11_280

تاریخ نمایه سازی: 7 اسفند 1396

Abstract:

Thin film solar cells with chalcopyrite CuInSe2/Cu(In,Ga)Se2 (CIS/CIGS) absorber layers have attracted significant research interest as an important light-to-electricity converter with widespread commercialization prospects. Among different deposition techniques available for the CIGS absorber layer, electrodeposition is an effective and low cost alternative to vacuum based deposition methods. Simultaneous electroplating of Cu-In-Ga-Se is so difficult due to the more negative potential of Ga and it does not come to a reasonable amount. Considerable researches have been done about this subject but there are still some points which needs more work specially on increasing the efficiency, and this work is following such researches. In this study two-step electroplating was used to deposit all four elements in the expected concentration level. Morphology and crystal structure of the films were characterized by X-ray diffraction (XRD) and scanning electron microscopy (SEM) to verify the existence of intermetallics.

Authors

Mohsen Saremi

Professor, university of Tehran School of Metallurgy & Materials Engineering, Faculty of Engineering, University of Tehran, Tehran, Iran.

Mahdis Nazarbeygi

Master student of Corrosion and Materials Protection, university of Tehran School of Metallurgy & Materials Engineering, Faculty of Engineering, University of Tehran, Tehran, Iran.

Negar Sabouhanian

Master student of Corrosion and Materials Protection, university of Tehran School of Metallurgy & Materials Engineering, Faculty of Engineering, University of Tehran, Tehran, Iran.