Effect of the shear rate and stabilization temperature on the foam density
عنوان مقاله: Effect of the shear rate and stabilization temperature on the foam density
شناسه ملی مقاله: ICHEC06_511
منتشر شده در ششمین کنگره بین المللی مهندسی شیمی در سال 1388
شناسه ملی مقاله: ICHEC06_511
منتشر شده در ششمین کنگره بین المللی مهندسی شیمی در سال 1388
مشخصات نویسندگان مقاله:
M . H . N Famili - Tarbiat Modares University, Chemical Engineering Department, Polymer Engineering Group, Tehran, Iran
Mohammad Ako - Tarbiat Modares University, Chemical Engineering Department, Polymer Engineering Group, Tehran, Iran
خلاصه مقاله:
M . H . N Famili - Tarbiat Modares University, Chemical Engineering Department, Polymer Engineering Group, Tehran, Iran
Mohammad Ako - Tarbiat Modares University, Chemical Engineering Department, Polymer Engineering Group, Tehran, Iran
Study the effect of shear rate and stabilization temperature on the foam density in wheat flour matrix was the objective of this research work. A twin screw extruder is used to mix and dissolve CO2 gas in the dough. Production of foam was done in three screw speed and extrudate foams were stabilized in three different temperatures (0, 25 and 50˚c). It was shown that at a given stabilization temperature, increase in screw speed, will increase foam density and at a given screw speed, an increase in stabilization temperature, will decrease foam density. It was also shown that increase of cell density leads to a decrease in foam density.
کلمات کلیدی: Glassy barrel twin screw extruder – Shear rate - Stabilization temperature – Foam density and wheat flour
صفحه اختصاصی مقاله و دریافت فایل کامل: https://civilica.com/doc/77783/