Evaluation of surface appearance parameters in automotive recoating: The effect of basecoat and clearcoat thickness
عنوان مقاله: Evaluation of surface appearance parameters in automotive recoating: The effect of basecoat and clearcoat thickness
شناسه ملی مقاله: ICAPC06_029
منتشر شده در ششمین کنگره بین المللی پوشش های حمل و نقل، ترافیک و ایمنی در سال 1398
شناسه ملی مقاله: ICAPC06_029
منتشر شده در ششمین کنگره بین المللی پوشش های حمل و نقل، ترافیک و ایمنی در سال 1398
مشخصات نویسندگان مقاله:
Mohammad Javad Shahla - Engineering Department, Tehran-West branch of Azad Islamic University
Setareh Qashqaei - Art and architecture Department, Tehran-Central branch of Azad Islamic University
خلاصه مقاله:
Mohammad Javad Shahla - Engineering Department, Tehran-West branch of Azad Islamic University
Setareh Qashqaei - Art and architecture Department, Tehran-Central branch of Azad Islamic University
The effect of clear coat and base coat thickness on the surface appearance parameters of Distinctness of Image (DOI) and waviness of the surface (LW, SW) have been studied. Results show that the optimum thickness of the base coat layer is 20 μm (confined limit of thickness), that any deviation from which, would adversely impact all appearance parameters whilst the effect of clear coat thickness could be varied. Although increase in clear coat thickness has positively contributed to a better performance in LW and DOI experiments, its influence on the SW results was slightly undesirable.
کلمات کلیدی: Distinctness of image (DOI); Clear coat/ Base coat; Automotive recoating; Waviness
صفحه اختصاصی مقاله و دریافت فایل کامل: https://civilica.com/doc/977444/