Effect of Aerodynamic Blade Change of Two-Stage Axial Subsonic Turbine on Design Point
Publish place: International Journal of Advanced Design and Manufacturing Technology، Vol: 12، Issue: 2
Publish Year: 1398
نوع سند: مقاله ژورنالی
زبان: English
View: 360
This Paper With 11 Page And PDF Format Ready To Download
- Certificate
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_ADMTL-12-2_007
تاریخ نمایه سازی: 27 فروردین 1399
Abstract:
In this research for reducing the effect of losses and increasing the efficiency, the bowing in the rotor and stator blades is used. In one mode rotor blades are curved and in other one, stator blades are curved. The amount of rotor loss, due to changes in the thickness of the trailing edge and operating rotational speed, have been investigated. To confirm the accuracy of the results, a turbine stage whose experimental results are available is modeled and numerical results have been compared with experimental results that indicate acceptable compliance. The turbulence model k-w-SST is used to solve turbulent flow. The positive bowing, creates a pressure gradient from the two ends of the blade towards the center of the blade, which leads to the directing of the secondary flows toward the center of the blade. This reduces the losses in the two ends of the blade and increases the loss in the middle part of the blade. Increasing the thickness of the trailing edge, as well as increasing the turbine’s operating rotational speed, will increase the loss. The curved rotor increases the efficiency and mass flow and power by 0.4% and 0.5% and 0.8% respectively and the curved nozzle reduces the efficiency and power by 0.3% and 4.9% but increases the mass flow by 0.2%. It also increases the thickness of the trailing edge of the first rotor from 0.2mm to 0.9mm at 24000 rotational speed and increases the total loss by about 35%.
Keywords:
Authors
Mahmood Adami
Department of Mechanical Engineering, Malek Ashtar University of Technology, Iran
Behrooz Shahriari
Department of Mechanical Engineering, Malek Ashtar University of Technology, Iran
Ali Zamani Gharaghoushi
Department of Mechanical Engineering, Malek Ashtar University of Technology, Iran
مراجع و منابع این Paper:
لیست زیر مراجع و منابع استفاده شده در این Paper را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود Paper لینک شده اند :