An Investigation in Effects of Tool Geometry and Friction Coefficient on the Maximum Drawing Force in Deep Drawing Process by Finite Element Method
Publish Year: 1389
نوع سند: مقاله کنفرانسی
زبان: English
View: 1,974
This Paper With 8 Page And PDF Format Ready To Download
- Certificate
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
NCNTME01_220
تاریخ نمایه سازی: 7 بهمن 1389
Abstract:
Many parameters are effective in deep drawing process. Some of these parameters that affect success or failure of a deep drawing process are tool geometry, friction coefficient and drawing force that cause the rupture and wrinkling in deep drawing process of axisymmetric hollow containers. In this paper, at first, a basic theory of deep drawing and also a review of various methodologies formulated for the finite element modeling of deep drawing were presented. Then a numerical model was developed to investigate the effects of friction coefficient and geometric parameters on maximum drawing force in the forming of sheet metal SPXI250 under simple cylindrical deep drawing conditions by finite element (FE) simulation done by using ABAQUS/EXPLICIT software. The required force for forming was examined in this paper. The results of simulations show that a change in friction coefficient between interface surfaces leads to a significant difference on the maximum drawing force of the punch and decrease the rupture in the blank and also the effect of the matrix radius on the drawing force is more important than the effect of the punch rim's radius. The results of this paper were compared with the Sieble's theory and experimental tests and with the results of the other researchers. There was a high level of agreement between the findings of the present study and the findings of the other researchers.
Keywords:
Authors
Ahmad Afsari
Faculty Member in Mechanical Engineering, Islamic Azad University, Shiraz Branch
Iman Rostamsowlat
M.Sc. in Mechanical Engineering, Islamic Azad University, Shiraz Branch and the Member of Young Researchers Club
Mohammad javad Kazemzadeh parsi
Faculty Member in Material Engineering, Islamic Azad University, Shiraz Branch
Maziar Janghorban
M.Sc. in Mechanical Engineering, Islamic Azad University, Shiraz Branch
مراجع و منابع این Paper:
لیست زیر مراجع و منابع استفاده شده در این Paper را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود Paper لینک شده اند :