CPFD Simulation of Gas-Solid Flow in Dense Phase Zone of Pant-Leg Fluidized Bed with Secondary Air

Aggregation of fluidization media may appear at the dense phase region of the pant-leg fluidized bed near the incline walls. When the particles flow along the inclined wall, the friction and drag force will cause the particles to accumulate on the inclined wall, resulting in an uneven distribution of particles. The stagnant zones can be minimized by correctly arranging secondary air. Computational particle fluid dynamics (CPFD) method was used to simulate the gas-solid two-phase flow pattern in the dense phase region of pant-leg fluidized bed. Cold tests were performed on a benchtop pant-leg fluidized bed. A high speed imaging technology was used to monitor the flow pattern in the dense phase area, whereas the bubble size and residence time were compared to verify the accuracy of the simulation. The gas-solid flow patterns under various models were simulated. The influence of different secondary air velocities on the reduction of stagnant zone in the dense phase zone of the fluidized bed were predicted. The results indicated that the introduction of secondary air could effectively promote the mixing of particles, and weaken the accumulation of particles on the inclined wall surface. Moreover, secondary air can effectively promote the flow between the gas-solid two-phases and improve the combustion characteristics in the furnace.

CPFD Simulation of Gas-Solid Flow in Dense Phase Zone of Pant-Leg Fluidized Bed with Secondary Air Keywords:

Fluidized bed , Dense phase zone , Gas-solid flow , Numerical simulation , Secondary air , CPFD