سیویلیکا را در شبکه های اجتماعی دنبال نمایید.

Analysing the Effect of Cassava Flour as a Mixture on the Physical, Mechanical, and Durability Properties of High-Strength Concrete

Publish Year: 1401
Type: Journal paper
Language: English
View: 96

This Paper With 17 Page And PDF Format Ready To Download

Export:

Link to this Paper:

Document National Code:

JR_CEJ-8-12_015

Index date: 21 April 2024

Analysing the Effect of Cassava Flour as a Mixture on the Physical, Mechanical, and Durability Properties of High-Strength Concrete abstract

The availability, cost, and environmental impact of chemical admixtures are reduced when natural substitute materials are incorporated into the concrete as an admixture. This paper outlines the findings of a study that looked at the physical characteristics of fresh and hardened concrete made with Portland pozzolanic cement CEM II/B-P blended with cassava flour up to 5% by weight of cement. A low water/binder ratio of 0.35 was used together with a carboxylate-based superplasticizing admixture to produce high strength. In fresh-state concrete, the initial and final setting times, soundness, and consistency were found to increase with increased cassava flour content, whereas the compacting factor and slump were observed to decrease. In the hardened state, compressive strengths were determined at 3, 7, 14, 28, 56, and 90 days, while split tensile and flexural strengths were investigated at 28 days. Similarly, dry density and porosity were also investigated at 28 days. Water absorption was also studied as a potential indicator of durability in hardened concrete. Scanning electron microscopy characterization of cassava flour revealed porous particles of irregular shape. On the other hand, X-ray diffraction imaging showed that the primary chemicals in cassava flour are silicon dioxide (50%), calcium oxide (17%), and aluminium oxide (7%). All of the mixes that incorporated cassava flour were stronger than the control mix, with the 3% cassava flour combination producing the best results. Doi: 10.28991/CEJ-2022-08-12-015 Full Text: PDF

Analysing the Effect of Cassava Flour as a Mixture on the Physical, Mechanical, and Durability Properties of High-Strength Concrete Keywords:

Analysing the Effect of Cassava Flour as a Mixture on the Physical, Mechanical, and Durability Properties of High-Strength Concrete authors

مراجع و منابع این Paper:

لیست زیر مراجع و منابع استفاده شده در این Paper را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود Paper لینک شده اند :
Kalra, M., & Mehmood, G. (2018). A Review paper on ...
Onikeku, O., Shitote, S. M., Mwero, J., & Adedeji, A. ...
Meyer, C. (2009). The greening of the concrete industry. Cement ...
Mohammed, T. U., Bin Harun, M. Z., & Joy, J. ...
Lazorenko, G., Kasprzhitskii, A., & Fini, E. H. (2022). Polyethylene ...
Schmidt, W., Olonade, K. A., Mbugua, R. N., Lenz, F. ...
Aïtcin, P. C. (2016). Supplementary cementitious materials and blended cements. ...
Guades, E. J. (2019). Effect of coarse aggregate size on ...
Kynclova, M., Fiala, C., & Hajek, P. (2011). High performance ...
Reddy, M. V. S., Sasi, K., Ashalatha, K., & Madhuri, ...
Koteng, D. O., & Chen, C. T. (2015). Strength development ...
Abdalla, T. A., Koteng, D. O., Shitote, S. M., & ...
Herring, T. C., Nyomboi, T., & Thuo, J. N. (2022). ...
Gupta, C. K., Sachan, A. K., & Kumar, R. (2022). ...
Saraswathy, V., Karthick, S., Lee, H. S., Kwon, S.-J., & ...
Okumu, V. A. (2018). Suitability of the Kenyan Blended Portland ...
Ahmed, A. (2019). Chemical Reactions in Pozzolanic Concrete. Modern Approaches ...
Hilal, A. A. (2016). Microstructure of Concrete. High Performance Concrete ...
Chu, S. H. (2019). Effect of paste volume on fresh ...
Akindahunsi, A. A. (2019). Investigation into the use of extracted ...
Gupta, S., & Kua, H. W. (2019). Carbonaceous micro-filler for ...
Khayat, K. H., & Mikanovic, N. (2012). Viscosity-enhancing admixtures and ...
Ortiz-Álvarez, N., Lizarazo-Marriaga, J., Brandão, P. F. B., Santos-Panqueva, Y., ...
Kannur, B., & Chore, H. S. (2021). Utilization of sugarcane ...
Oluwabusayo Oni, D., Mwero, J., & Kabubo, C. (2020). Experimental ...
Faqe, H., Dabaghh, H., & Mohammed, A. (2020). Natural Admixture ...
Abd, S. M., Hamood, Q. Y., & Khamees. (2016). Effect ...
Adeleke, B. K., GARBA, M., Alfa, N. M., & Dahiru, ...
Mbugua, R., Salim, R., & Ndambuki, J. (2016). Effect of ...
Uchechukwu Elinwa, A. (2017). Effects of Gum Arabic Admixture on ...
Anandaraj, S., Karthik, S., Vijaymohan, S., Rampradheep, G. S., Indhiradevi, ...
Kuznetsov, E., Pustovgar, A., Ivanova, I., Medvedev, V., & Elenova, ...
Alhozaimy, A., Fares, G., Alawad, O. A., & Al-Negheimish, A. ...
Kone, B., Mwero, J. N., & Ronoh, E. K. (2022). ...
Akpokodje, O. I., Agbi, G. G., & Uguru, H. (2020). ...
Okafor, F. O. (2010). The Performance of Cassava Flour As ...
FAO. (2015). Food Outlook-Biannual report on Global Food markets Food ...
Surtono, A., Aprilliana, P., Supriyanto, A., Pauzi, G. A., Junaidi, ...
Akindahunsi, A. A., & Uzoegbo, H. C. (2015). Strength and ...
Akindahunsi, A. A., & Schmidt, W. (2017). Effect of cassava ...
Ikoko, O. (2021). Evaluating the Compressive Strength of Wood Shavings-Cassava ...
Sybis, M., & Konował, E. (2022). Influence of Modified Starch ...
Souza, J. M. de, Ramos Filho, R. E. B., Duarte, ...
Adedokun, S. I., Adebisi, A. N., Omileye, A. A., Afolayiwola, ...
Akpokodje, O. I., & Uguru, H. (2019). Effect of fermented ...
Schmidt, W., Tchetgnia Ngassam, I. L., Olonade, K. A., Mbugua, ...
Sinkhonde, D., Rimbarngaye, A., Kone, B., & Herring, T. C. ...
ASTM C33/C33M – 18. (2018). Standard Specification for Concrete Aggregates. ...
ASTM D75/D75-19. (2019). Standard Method of Test for Sampling of ...
ASTM C128-01. (2017). Standard Test Method for Density, Relative Density ...
ASTM C29/C29M-09. (2016). Standard Test Method for Bulk Density (Unit ...
ACI 211.4R-08. (2008). Guide for Selecting Proportions for High-strength Concrete ...
BS EN 206:2013. (2013). Concrete - Specification, performance, production and ...
BS EN 196-3. (2005). Methods of testing cement. Determination of ...
IS: 4031 (Part4)-1988. (1997). Methods of Physical Tests for Hydraulic ...
Tariq, K. A., Sohaib, M., & Baig, M. A. (2021). ...
Gupta, G., & Pal, P. (2020). A Study on Self ...
Singh, M. K. G., & Venkatanarayanan, H. K. (2020). Performance ...
Xavier, J. R. (2020). Investigation on the anticorrosion, adhesion and ...
Agbi, G. G., & Uguru, H. (2021). Assessing the impact ...
Oni, D., Mwero, J., & Kabubo, C. (2020). The Effect ...
Marar, K., & Eren, Ö. (2011). Effect of cement content ...
نمایش کامل مراجع