Investigating the Level of Metal’s Toxicity in Used Cell Phone Batteries by TCLP and WET Methods

Introduction: Batteries are widely used in all kinds of electrical and electronic equipment. These batteries contain several metals that lead to the leakage of metals into the soil and underground water in the burial places, which pose serious risks to human health and the environment. Materials and Methods: In this study, the concentration of ۱۵ metals (Ag, Al, As, Ba, Cd, Co, Cs, Cu, Fe, Li, Mn, Pb, Sr, Zn, Ni) in different components of ۷ used battery models was investigated using Waste Extraction Test (WET) and Toxicity Characteristic Leaching Procedure (TCLP) toxicity. The concentration of metals was measured by Inductively Coupled Plasma Optical Emission Spectroscopy (ICP-OES). Metal concentrations were compared with the United States Environmental Protection Agency (USEPA) and California Department of Toxic Substances Control (CDTSC) standards.  Results: The results showed that the average concentration of metals in both WET and TCLP methods was high, but the concentration of most metals in WET method was relatively higher than in TCLP method. Conclusion: The results showed that the recovery of metals from batteries is necessary, moreover  safe burial of  batteries is essential to reduce environmental risks.

Keywords:

Batteries , Metals , Electronic waste , Environmental pollution , Toxicity , Waste Extraction Test , Toxicity Characteristic Leaching Procedure