Application of a low heat input deposition process for refurbishment of worn PM forming Dies using Nickel based filler metal
Publish place: 6TH INTERNATIONAL PM AUTO CONFERENCE
Publish Year: 1397
نوع سند: مقاله کنفرانسی
زبان: English
View: 367
متن کامل این Paper منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل Paper (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- Certificate
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
PMAUTO06_011
تاریخ نمایه سازی: 23 آذر 1397
Abstract:
Refurbishment of worn Dies is an interesting research area which also has high economic benefit. Material which is used in PM dies for compacting powders are hich carbon steel which have very low weldabilitis. Due to the high hardness, high carbon content and martensitic microstructure, thsese Dies are very sensitive to the thermal shock produced from fusion welding. For sucsessfully refurbishing the worn Dies, Fine spark deposition was used for deposition of a new layer on the cold work 1.2436 steel. Different heat inputs were used for deposition of nickel based material and finally microstructure and HAZ were studied. Results show the HAZ area is very narrow, free from cracks and HAZ microstructure is similar to the base metal. GTAW welding using same filler metal induced many cracks in HAZ of weld which is detrimental to the refurbished Die performance. Results show increasing heat input in Fine spark deposition can results in crack formation in HAZ even if the weld pool does not occurred in base metal. However these cracks are much smaller than those occurred in GTAW.
Keywords:
Authors
Mohamad Ebrahimnia
Material science and engineering department, Islamic Azad university, Science and research branch Tehran, Iran
Hamzeh baghjari
Material Engineering , Tarbiat Modares University
Alireza Hajesmaeli
Mashhad Powder metallurgy Company, R&D and Engineering department
Milad Hojati
Mashhad Powder metallurgy Company, R&D and Engineering department