Influence of Welding Parameters on Strength of Friction Stir Spot Welded Polyethylene Sheets Using Two-Stage Refilling Process
Publish place: International Conference on Manufacturing Engineering
Publish Year: 1397
نوع سند: مقاله کنفرانسی
زبان: English
View: 461
متن کامل این Paper منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل Paper (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- Certificate
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICME15_014
تاریخ نمایه سازی: 3 اردیبهشت 1398
Abstract:
There are different joining processes for thermoplastic composites. Friction stir spot welding by using two-stage refilling process has been introduced recently. In this paper, the feasibility of performing this process on polyethylene sheets is studied. Also, the effects of the main weldingparameters including the tool rotational speed and the refilling time on the welding strength were investigated using the response surface method (RSM). The results confirm that this process is applicable on polymer sheets. It is concluded that the tool rotational speed is the mostinfluential parameter, then followed by refilling time. The results also indicate that the increase of the tool rotational speed results in the reduction of the joint strength, and the decrease of the refilling time increases the welding strength. The best obtained strength proposed by theresponse surface optimizer was 798 MPa, which was obtained with tool rotational speed of 1200 rpm and refilling time of 19.82 s.
Keywords:
Friction stir spot welding- Polyethylene sheet- Two-stage refilling – Welding strength.
Authors
Farshad Akbari
MSc. Student, Mechanical engineering department, University of Birjand, Birjand, Iran
Moosa Sajed
PhD Student, Mechanical engineering department, University of Birjand, Birjand, Iran
Amir Ashrafi
Assistant Prof., Mechanical Engineering Dept., University of Birjand, Birjand, Iran
S. M. Hossein Seyedkashi
Associate Prof., Mechanical Engineering Dept., University of Birjand, Birjand, Iran